2018–2024 · saloon
Toyota Camry XV70 wheel fitment
The XV70 Camry came on 16 to 19-inch wheels depending on grade, with the sporty XSE on 19x8s and the TRD on wider 19x8.5s over larger front brakes. Most wheel changes are 18 or 19-inch upgrades on four-cylinder and hybrid cars, so the main things to check are offset and, on TRD cars, brake clearance.
5x114.3 bolt pattern · 60.1 mm centre bore · Stock wheels: 17 × 7.5, 16 × 6.5, 18 × 8, 19 × 8, 19 × 8.5 inch · Stock tyres: 215/55 R17, 205/65 R16, 235/45 R18, 235/40 R19
Updated 2026-10-31 · Medium source confidence. Check your exact trim and market. How we check specs
Quick specs
| Specification | Value |
|---|---|
| Bolt pattern | |
| Stock tyre sizes | |
| Centre bore | 60.1 mm |
| Fastener and thread | Wheel nut, M12x1.5 |
| Tightening torque | 103 Nm (confirm in your handbook) |
Stock wheels and tyres
Factory options vary by trim and market. Match your car to the row below and check its tyre placard before using it as a baseline.
| Trim | Axle | Wheel | Tyre |
|---|---|---|---|
| LE, 17-inch | Front and rear | 17 × 7.5 inch, ET45 | 215/55 R17 |
| L and Hybrid LE, 16-inch | Front and rear | 16 × 6.5 inch, ET40 | 205/65 R16 |
| SE / XLE incl. V6, 18-inch | Front and rear | 18 × 8 inch, ET50 | 235/45 R18 |
| XSE, 19-inch | Front and rear | 19 × 8 inch, ET50 | 235/40 R19 |
| TRD (2020 on), 19-inch | Front and rear | 19 × 8.5 inch, ET45 | 235/40 R19 |
Explained in our guides
Read these before choosing wheels for the Camry: they explain the offset, fitment and hub numbers in this guide.
- Wheel offset explained: choosing ET without guessingUnderstand positive and negative wheel offset, calculate inner clearance and outer position, and choose an ET using measurements from your own car.
- Flush, poke and tucked fitment: measure the whole tyreUnderstand flush, poked and tucked wheels, calculate how width and offset change the look, and check clearance beyond a parked side-on photograph.
- Hub-centric vs lug-centric wheels: choosing hub ringsLearn what hub rings do, how to specify their inner and outer diameters, and why centring, wheel seats and vibration need separate checks.
Popular community setups
Starting points for a build. Read the notes with each setup, especially if your car is lowered or has different brakes.
No community setups have been checked yet.
Width and offset guidance
Offset range
Check the exact setup
There is no confirmed range for this car yet. Compare a known wheel with your proposed size and measure both sides.
Common width limit
Measure before ordering
A maximum width has not been confirmed. Tyre shape, ride height and alignment all change the available space.
These figures belong to the setups described here. Combining the widest wheel with either end of the offset range does not guarantee a safe fit. For how ET moves the wheel in and out, read wheel offset explained; for how far the tyre can sit out, see flush, poke and tucked fitment.
Clearance notes
- Every XV70 Camry uses 5x114.3 with a 60.1 mm centre bore and M12x1.5 wheel nuts, torqued to 103 Nm. Most aftermarket wheels have a larger bore and need hub-centric rings.
- The TRD has 12.9-inch front discs with twin-piston calipers, against 12-inch discs on other grades, and sits about 15 mm lower on its own springs. Check that any wheel clears the TRD calipers, and do not assume 16 or 17-inch wheels will.
- Fitment databases list the 19x8.5 wheel at ET45. Launch coverage describes the TRD wheel as half an inch wider than the XSE's 19x8, but we have not seen its offset in Toyota's own material.
- The 16, 17, 18 and 19-inch factory tyres are all within about 1.5% of each other in diameter, so moving between factory sizes keeps the speedometer close.
- We have not yet confirmed owner-documented aftermarket setups for this generation, so none are listed here.
- Check full steering lock and suspension travel with the car loaded. Match wheel load rating, tyre load and speed ratings, fastener seats and brake clearance.
See it on your car.
Upload a photo and start with a look that suits the Camry. Try the wheels, colour and stance before you spend on parts.
An AI preview shows the look. It cannot verify physical fitment.
Run the numbers
These tools start with the LE, 17-inch front size. Choose your own trim or axle in the calculator if it differs.
Questions
What is the bolt pattern of the 2018–2024 Camry?
5x114.3, with a 60.1 mm centre bore and M12x1.5 wheel nuts.
What size are the Camry XSE and TRD wheels?
The XSE uses 19x8 ET50 wheels and the TRD 19x8.5 wheels, both on 235/40 R19 tyres.
Can I fit 19-inch XSE wheels to a Camry LE?
They share the bolt pattern and bore, and the 235/40 R19 tyre is within about 1% of the diameter of the LE's 215/55 R17, so the factory XSE wheel and tyre is a like-for-like upgrade.
What is the wheel nut torque on an XV70 Camry?
103 Nm, which is 76 lb-ft.
What size tyres does the Toyota Camry XV70 have?
Factory tyre (tire) sizes for the 2018–2024 Toyota Camry XV70 are 215/55 R17, 205/65 R16, 235/45 R18 and 235/40 R19, depending on trim. Your tyre placard shows the size for your car.
What wheel size does the Toyota Camry XV70 use?
Factory wheels are 17 × 7.5 inch, 16 × 6.5 inch, 18 × 8 inch, 19 × 8 inch and 19 × 8.5 inch, depending on trim. The stock table lists the offset for each.
What is the Toyota Camry XV70 centre bore?
60.1 mm. Aftermarket wheels with a larger bore need hub-centric rings sized to it.
Specs checked against
- TireWheelGuide: 2020 Camry factory sizes, bore and thread
- TireWheelGuide: 2023 Camry factory sizes
- iSeeCars: 2019 Camry wheel size by trim
- TireSize.com: 2019 Camry Hybrid LE tyre size
- Wheel-Sizes.com: Camry lug nut thread and torque
- Kelley Blue Book: 2020 Camry TRD first look
- Automoblog: Camry TRD wheels, tyres and lowering
This guide is a starting point, not a fitment guarantee. Specs can differ by market, trim and previous modifications. Confirm all sizes, clearances and fastener requirements with a qualified wheel and tyre professional before buying or fitting parts.
Related cars
More guides from Toyota or cars with the same bolt pattern. A matching pattern alone does not make a wheel interchangeable.