2023–present · coupe
The RZ34 retains staggered wheel offsets, even on the Sport model with equal front and rear tyre sizes. Performance and Nismo versions have wider rear tyres and larger brakes that need specific wheel-clearance checks.
5x114.3 bolt pattern · 66.1 mm centre bore · Stock wheels: 18 × 9, 19 × 9.5, 19 × 10, 19 × 10.5 inch · Stock tyres: 245/45 R18, 255/40 R19, 275/35 R19, 285/35 R19
Updated 2026-10-04 · High source confidence. Check your exact trim and market. How we check specs
| Specification | Value |
|---|---|
| Bolt pattern | |
| Stock tyre sizes | |
| Centre bore | 66.1 mm |
| Fastener and thread | Wheel nut, M12x1.25 |
| Tightening torque | 108 Nm (confirm in your handbook) |
Factory options vary by trim and market. Match your car to the row below and check its tyre placard before using it as a baseline.
| Trim | Axle | Wheel | Tyre |
|---|---|---|---|
| Sport | Front | 18 × 9 inch, ET34 | 245/45 R18 |
| Sport | Rear | 18 × 9 inch, ET15 | 245/45 R18 |
| Performance / Proto Spec | Front | 19 × 9.5 inch, ET40 | 255/40 R19 |
| Performance / Proto Spec | Rear | 19 × 10 inch, ET30 | 275/35 R19 |
| Nismo | Front | 19 × 10 inch, ET33 | 255/40 R19 |
| Nismo | Rear | 19 × 10.5 inch, ET23 | 285/35 R19 |
Read these before choosing wheels for the Z: they explain the offset, fitment and hub numbers in this guide.
Starting points for a build. Read the notes with each setup, especially if your car is lowered or has different brakes.
Nismo specifies this combination for the RZ34 Nismo. Its tuner-size guidance calls for specialist installation and sufficient lowering, camber or arch coverage to keep the wheels inside the body. Use the specified tapered-seat nuts.
An RZ34 owner reports this staggered combination. The source does not establish a complete tyre specification or suspension condition, so tyre sizes are omitted.
Check the exact setup
There is no confirmed range for this car yet. Compare a known wheel with your proposed size and measure both sides.
Measure before ordering
A maximum width has not been confirmed. Tyre shape, ride height and alignment all change the available space.
These figures belong to the setups described here. Combining the widest wheel with either end of the offset range does not guarantee a safe fit. For how ET moves the wheel in and out, read wheel offset explained; for how far the tyre can sit out, see flush, poke and tucked fitment.
Upload a photo and start with a look that suits the Z. Try the wheels, colour and stance before you spend on parts.
An AI preview shows the look. It cannot verify physical fitment.
These tools start with the Sport front size. Choose your own trim or axle in the calculator if it differs.
5x114.3 with a 66.1 mm centre bore and M12x1.25 wheel nuts.
Nissan’s Japanese RZ34 owner instructions specify 108 Nm.
Both are 18x9, but the front is ET34 and the rear ET15. The tyre size is 245/45 R18 at both ends.
Use the tapered-seat hardware specified by Nismo for LMGT4 wheels. Matching the thread alone is insufficient.
Factory tyre (tire) sizes for the 2023–present Nissan Z RZ34 are 245/45 R18, 255/40 R19, 275/35 R19 and 285/35 R19, depending on trim, with wider rears on staggered setups. Your tyre placard shows the size for your car.
Factory wheels are 18 × 9 inch, 19 × 9.5 inch, 19 × 10 inch and 19 × 10.5 inch, depending on trim. The stock table lists the offset for each.
66.1 mm. Aftermarket wheels with a larger bore need hub-centric rings sized to it.
This guide is a starting point, not a fitment guarantee. Specs can differ by market, trim and previous modifications. Confirm all sizes, clearances and fastener requirements with a qualified wheel and tyre professional before buying or fitting parts.
More guides from Nissan or cars with the same bolt pattern. A matching pattern alone does not make a wheel interchangeable.