2001–2006 · coupe

Holden Monaro / Pontiac GTO V2/VZ wheel fitment

The V2 and VZ Monaro, sold in the US as the 2004–2006 Pontiac GTO, came on 17 or 18-inch wheels 8 inches wide at ET48. Owners usually go to wider 18 or 19-inch wheels, often with a 9.5-inch rear, and drag-racing GTOs often fit the widest rear tyre the arches will take. The rear arch lip, not the brakes, is what limits most setups.

5x120 bolt pattern · 69.5 mm centre bore · Stock wheels: 18 × 8, 17 × 8 inch · Stock tyres: 235/40 R18, 235/45 R17, 245/45 R17

Updated 2026-10-31 · High source confidence. Check your exact trim and market. How we check specs

Quick specs

Holden Monaro / Pontiac GTO V2/VZ hub and fastener specifications
SpecificationValue
Bolt pattern
Stock tyre sizes
Centre bore69.5 mm
Fastener and threadWheel nut, M12x1.5
Tightening torqueConfirm in your handbook

Stock wheels and tyres

Factory options vary by trim and market. Match your car to the row below and check its tyre placard before using it as a baseline.

Factory wheels and tyres by trim and axle
TrimAxleWheelTyre
Monaro CV8, 18-inchFront and rear18 × 8 inch, ET48235/40 R18
Monaro CV6, 17-inchFront and rear17 × 8 inch, ET48235/45 R17
Pontiac GTO, standard 17-inchFront and rear17 × 8 inch, ET48245/45 R17
Pontiac GTO, optional 18-inchFront and rear18 × 8 inch, ET48235/40 R18

Read these before choosing wheels for the Monaro / Pontiac GTO: they explain the offset, fitment and hub numbers in this guide.

Popular community setups

Starting points for a build. Read the notes with each setup, especially if your car is lowered or has different brakes.

18-inch staggered, 8.5 ET45 front and 9.5 ET58 rear

Front
18 × 8.5 inch, ET45 · 245/40 R18
Rear
18 × 9.5 inch, ET58 · 275/35 R18

Apex's GTO fitment guide marks this as its popular staggered fitment and lists it as a direct fit, with 245/40 R18 front and 275/35 R18 rear tyres. A 255/35 R18 front is listed as a wider alternative. Apex also offers the front at ET40.

18x8.5 ET35 square

Front and rear
18 × 8.5 inch, ET35 · 245/40 R18

Apex lists 18x8.5 at ET35, ET40 or ET45 all round as a direct fit with 245/40 R18 tyres. It describes ET45 as a factory-style fitment and ET35 as a flusher aftermarket look.

18x9 ET42 square

Front and rear
18 × 9 inch, ET42 · 255/40 R18

Apex lists this as a direct fit with 255/40 R18 tyres on factory brakes, but says cars converted to CTS-V brakes need a 1/4-inch (about 6 mm) front spacer.

17x9 ET42 square

Front and rear
17 × 9 inch, ET42 · 245/40 R17

Apex's 17-inch square option, a direct fit with 245/40 R17 tyres. A wider 255/40 R17 may need around -1.5 degrees of front camber on some cars.

Staggered 19s, 8.5 front and 9.5 rear

Front
19 × 8.5 inch, ET35
Rear
19 × 9.5 inch, ET40

A GTO owner on the LS1Tech forum reports running 19x8.5 ET35 front and 19x9.5 ET40 rear wheels with 275-wide rear tyres and says they have never rubbed, with the rear on drag bags at low pressure. He doesn't give the front tyre size; 245/35 R19 is within about 1.5% of the factory 18-inch tyre's diameter.

Width and offset guidance

Offset range

Check the exact setup

There is no confirmed range for this car yet. Compare a known wheel with your proposed size and measure both sides.

Common width limit

Measure before ordering

A maximum width has not been confirmed. Tyre shape, ride height and alignment all change the available space.

These figures belong to the setups described here. Combining the widest wheel with either end of the offset range does not guarantee a safe fit. For how ET moves the wheel in and out, read wheel offset explained; for how far the tyre can sit out, see flush, poke and tucked fitment.

Clearance notes

  • Monaro and GTO share the 5x120 pattern, 69.5 mm centre bore and M12x1.5 wheel nuts, the same as VT to VZ Commodores. Wheels with a 72.6 or 73.1 mm bore need hub-centric rings.
  • The 17 and 18-inch factory wheels are all 8 inches wide at ET48, so the factory tyre is the main difference between Monaro and GTO sizes. Fitment databases also list a 19x8.5 ET43 wheel with 245/35 R19 as an option on the VZ Monaro.
  • The rear arches are the tight spot for wide tyres. On the LS1Tech forum, one GTO with a 275/40 R18 rear tyre caught the arch even after its lips were shaved, and another on 285/35 R18 drag radials rubbed slightly under hard squat despite ground-off lips and reshaped inner wheel arches.
  • VE and VF Commodore wheels have a smaller centre bore, about 67 mm, so they won't seat on this hub without machining.
  • We have not confirmed the factory wheel-nut torque for the Monaro or GTO. Use the figure in the owner's handbook.
  • Check full steering lock and suspension travel with the car loaded. Match wheel load rating, tyre load and speed ratings, fastener seats and brake clearance.

See it on your car.

Upload a photo and start with a look that suits the Monaro / Pontiac GTO. Try the wheels, colour and stance before you spend on parts.

An AI preview shows the look. It cannot verify physical fitment.

Run the numbers

These tools start with the Monaro CV8, 18-inch front size. Choose your own trim or axle in the calculator if it differs.

Questions

What is the bolt pattern of a Holden Monaro or 2004–2006 Pontiac GTO?

5x120, with a 69.5 mm centre bore and M12x1.5 wheel nuts. Both cars are the same underneath.

What size are the factory GTO wheels?

17x8 ET48 with 245/45 R17 tyres as standard, or 18x8 ET48 with 235/40 R18 as the option. The Monaro CV8 came on 18x8 ET48 with 235/40 R18, and the CV6 on 17x8 ET48 with 235/45 R17.

Do VT to VZ Commodore wheels fit a Monaro?

Yes. They use the same 5x120 drilling and 69.5 mm hub, and most 17 and 18-inch factory wheels from those cars are 8 inches wide at ET48 like the Monaro's own.

Will a 275 rear tyre fit a GTO?

Apex lists 275/35 R18 on an 18x9.5 ET58 rear as a direct fit, and one owner reports no rubbing with 275s on 19x9.5 ET40 rears. Taller 275/40 R18 and wider drag tyres have caught the rear arch on other cars, even with the lips rolled or ground, so check rear clearance with the car loaded.

What size tyres does the Holden Monaro / Pontiac GTO V2/VZ have?

Factory tyre (tire) sizes for the 2001–2006 Holden Monaro / Pontiac GTO V2/VZ are 235/40 R18, 235/45 R17 and 245/45 R17, depending on trim. Your tyre placard shows the size for your car.

What wheel size does the Holden Monaro / Pontiac GTO V2/VZ use?

Factory wheels are 18 × 8 inch and 17 × 8 inch, depending on trim. The stock table lists the offset for each.

What is the Holden Monaro / Pontiac GTO V2/VZ centre bore?

69.5 mm. Aftermarket wheels with a larger bore need hub-centric rings sized to it.

Specs checked against

Related cars