2007–2014 · hatchback
The second-generation Fit, sold in Europe and Australia as the Jazz, came on 14, 15 or 16-inch wheels, with the US Sport and 16-inch versions elsewhere on 16x6 alloys. It is light enough that owners often go wider rather than bigger, typically a 7-inch wheel in 15, 16 or 17 inches with a 205-section tyre, kept near ET40 to ET45 so it stays inside the arches.
4x100 bolt pattern · 56.1 mm centre bore · Stock wheels: 16 × 6, 15 × 5.5, 14 × 5.5 inch · Stock tyres: 185/55 R16, 175/65 R15, 175/65 R14
Updated 2026-10-31 · High source confidence. Check your exact trim and market. How we check specs
| Specification | Value |
|---|---|
| Bolt pattern | |
| Stock tyre sizes | |
| Centre bore | 56.1 mm |
| Fastener and thread | Wheel nut, M12x1.5 |
| Tightening torque | 108 Nm (confirm in your handbook) |
Factory options vary by trim and market. Match your car to the row below and check its tyre placard before using it as a baseline.
| Trim | Axle | Wheel | Tyre |
|---|---|---|---|
| Fit Sport (US) / 16-inch Fit and Jazz alloy | Front and rear | 16 × 6 inch, ET53 | 185/55 R16 |
| Fit base / Jazz, 15-inch | Front and rear | 15 × 5.5 inch, ET45 | 175/65 R15 |
| Japanese-market 1.3, 14-inch | Front and rear | 14 × 5.5 inch, ET45 | 175/65 R14 |
Read these before choosing wheels for the Fit / Jazz: they explain the offset, fitment and hub numbers in this guide.
Starting points for a build. Read the notes with each setup, especially if your car is lowered or has different brakes.
A common FitFreak GE8 recommendation. One owner lowered by about 2 inches reported no rubbing at ET45 with 205/45 R16, while the same car rubbed at the front on hard turns with ET40 and taller 185/55 tyres.
Owners on FitFreak running 15x7 ET38 wheels on Swift Sport springs report no rubbing, even in turns, with 205/55 R15. It keeps a taller sidewall and is close to the factory 16-inch tyre's diameter.
A FitFreak member at standard ride height reported no rubbing at all on 17x7 ET42 with 205/40 R17. The same owner had heavy rear rubbing when spacers brought the rear offset down to about ET15.
ET38 to ET53
Owner setups on 7-inch wheels run from about ET38 to ET45 without rubbing. Lower offsets start to rub at the front, especially when lowered.
7 inch
FitFreak owners treat 7 inches as the practical limit without fender work. 7.5 and 8-inch wheels are run, but owners report rubbing or rolled arches.
These figures belong to the setups described here. Combining the widest wheel with either end of the offset range does not guarantee a safe fit. For how ET moves the wheel in and out, read wheel offset explained; for how far the tyre can sit out, see flush, poke and tucked fitment.
Upload a photo and start with a look that suits the Fit / Jazz. Try the wheels, colour and stance before you spend on parts.
An AI preview shows the look. It cannot verify physical fitment.
These tools start with the Fit Sport (US) / 16-inch Fit and Jazz alloy front size. Choose your own trim or axle in the calculator if it differs.
4x100, with a 56.1 mm centre bore and M12x1.5 wheel nuts torqued to 108 Nm.
16x6 ET53 with 185/55 R16 tyres. The base Fit and most European Jazz models use 15x5.5 ET45 with 175/65 R15.
On a 7-inch wheel, owners report ET40 to ET45 as the safe range. Lower offsets tend to rub on the front liners, particularly on lowered cars without extra camber.
Some owners run them on 16x7 ET40 to ET45 without trouble, but reports are mixed on lowered cars. 205/45 R16 is the safer choice and is closer to the factory diameter.
They use the same 4x100 pattern and hub bore, so they bolt on. Check the offset and width against the factory ET53.
Factory tyre (tire) sizes for the 2007–2014 Honda Fit / Jazz GE are 185/55 R16, 175/65 R15 and 175/65 R14, depending on trim. Your tyre placard shows the size for your car.
Factory wheels are 16 × 6 inch, 15 × 5.5 inch and 14 × 5.5 inch, depending on trim. The stock table lists the offset for each.
56.1 mm. Aftermarket wheels with a larger bore need hub-centric rings sized to it.
108 Nm (about 80 lb-ft) for the original nuts. Confirm in your handbook, especially with aftermarket wheels or nuts.
This guide is a starting point, not a fitment guarantee. Specs can differ by market, trim and previous modifications. Confirm all sizes, clearances and fastener requirements with a qualified wheel and tyre professional before buying or fitting parts.
More guides from Honda or cars with the same bolt pattern. A matching pattern alone does not make a wheel interchangeable.
2008–2012 · 5x114.3
2013–2017 · 5x114.3
2018–2022 · 5x114.3
2006–2011 · 5x114.3
2012–2015 · 5x114.3
2016–2021 · 5x114.3