20-inch rim · tyre size comparison
245/40 R20 vs 245/45 R20
245/45 R20 is 24.5 mm (0.96 in) taller than 245/40 R20, a +3.48% difference in overall diameter. That is just outside the ±3% limit commonly used to screen a tire size change, so expect a noticeable speedometer error; it is a nominal calculation, not a fitment approval.
- Diameter difference
- +24.5 mm
- +0.96 in · +3.48%
- Indicated 70 mph
- 72.4 mph
- Actual speed on 245/45 R20, if the speedometer was accurate on 245/40 R20.
- Sidewall height
- +12.25 mm
- 98 mm to 110.25 mm.
Dimensions side by side
| Measurement | 245/40 R20 | 245/45 R20 | Difference |
|---|---|---|---|
| Overall diameter | 704 mm27.72 in | 728.5 mm28.68 in | +24.5 mm (+3.48%)+0.96 in |
| Section width | 245 mm9.65 in | 245 mm9.65 in | 0 mm0 in |
| Sidewall height | 98 mm3.86 in | 110.25 mm4.34 in | +12.25 mm+0.48 in |
| Circumference | 2,211.68 mm87.07 in | 2,288.65 mm90.1 in | +76.97 mm+3.03 in |
| Rim diameter | 508 mm20 in | 508 mm20 in | 0 mm0 in |
| Revolutions per mile | 727.66 | 703.18 | -24.47 |
| Revolutions per km | 452.14 | 436.94 | -15.21 |
Calculated from the nominal size codes, without load or tread wear. Real tyres vary by model, rim width and pressure, so the exact tyre's published dimensions take priority.
Speedometer with 245/45 R20
If the speedometer was accurate on 245/40 R20, fitting 245/45 R20 means the car is travelling 3.48% faster than it shows, and the odometer under-records distance by about the same amount.
| Speedometer shows | Actual on 245/45 R20 | Difference |
|---|---|---|
| 30 mph | 31.04 mph | +1.04 mph |
| 50 mph | 51.74 mph | +1.74 mph |
| 60 mph | 62.09 mph | +2.09 mph |
| 70 mph | 72.44 mph | +2.44 mph |
| 50 km/h | 51.74 km/h | +1.74 km/h |
| 100 km/h | 103.48 km/h | +3.48 km/h |
UN ECE Regulation 39, used in the UK and EU, does not allow a speedometer to show less than the true speed, so many read slightly high from the factory. A taller tyre uses up some of that margin. Calibration varies by car; these figures are the tyre-size effect only.
What changes from 245/40 R20 to 245/45 R20
Wheels
Both fit 20-inch wheels. Our rim-width starting estimate is 7.5 to 8.5 inches for 245/40 R20 and 7.5 to 8.5 inches for 245/45 R20, so a 7.5 to 8.5-inch wheel sits in both ranges. The exact tyre's approved rim range takes priority.
Sidewall and ride comfort
245/45 R20 has 12.25 mm more sidewall (110.25 vs 98 mm). A taller sidewall usually rides a little softer and gives the rim more protection from potholes and kerbs, at the cost of some steering sharpness.
Contact width
Both are 245 mm in nominal section width, so the tread is about as wide. Contact patch area is set mostly by load and pressure, so grip differences come more from the tyre model than this size change.
Wheel well clearance
Ride height changes by about +12.3 mm, and the top of the tyre moves the same distance closer to the arch. On the same wheel, the sidewalls stay in roughly the same place side to side. Check clearance at full steering lock and full suspension compression, especially on a lowered car.
Gearing
The effective final drive changes by -3.36%: 3,000 rpm at a given road speed becomes about 2,900 rpm. Gearing gets noticeably longer, so cruising revs drop and acceleration in each gear softens.
ABS, stability control and AWD
These systems compare wheel speeds. Fit the same size on both ends of an axle; with a 3.5% diameter gap, never mix 245/40 R20 and 245/45 R20 on an AWD car, and follow the car maker's rolling-circumference limits, which can be much tighter than 3%.
General tendencies from the nominal numbers, not a test of any tyre. Load index, speed rating, tyre construction and the car's approved sizes matter more than these rules of thumb.
Explained in our guides
- Plus-sizing wheels: tyre diameter and speedometer changesWork through a 17 to 18 inch wheel change, compare tyre diameters and speedometer effects, and understand why a 3% rule cannot approve fitment.
- Staggered vs square wheels: tyres, rotation and AWDCompare square and staggered wheel setups, calculate front-to-rear tyre diameter, and understand rotation limits and all-wheel-drive requirements.
- How to read a tyre size, load index and sidewall markingsDecode tyre width, aspect ratio, rim diameter, load and speed markings, then calculate sidewall height and diameter using a 225/45 R17 example.
Cars in our guides using these sizes
Factory trims and popular community setups from our fitment guides. A popular setup is not a factory approval; each guide explains its trims, axles and clearance limits.
245/40 R20
- Chevrolet Camaro 6th gen (2016–2024)Factory trim
245/45 R20
- Chevrolet Camaro 5th gen (2010–2015)Factory trim
- Dodge Challenger LC (2008–2023)Factory trim
- Dodge Charger LD (2011–2023)Factory trim
More comparisons
245/40 R20 compared
245/45 R20 compared
Questions
Can I use 245/45 R20 instead of 245/40 R20?
Both fit 20-inch wheels. The diameter difference is +3.48%, just outside the ±3% screening limit, so most fitters would treat it as a different size class rather than a direct replacement. That does not approve fitment: check the car maker's approved sizes, load index, speed rating, rim width and clearance first.
How much bigger is 245/45 R20 than 245/40 R20?
Overall diameter is 24.5 mm (0.96 in) larger: 728.5 vs 704 mm. Section width is the same, and the sidewall is 12.25 mm taller. These are nominal figures; real tyres vary by model and rim width.
Will 245/45 R20 change my speedometer reading?
Yes, by 3.48%. If the speedometer was accurate on 245/40 R20, an indicated 60 mph would be about 62.1 mph on 245/45 R20, and an indicated 100 km/h about 103.5 km/h. You would be going faster than the speedometer shows.
Which is better, 245/40 R20 or 245/45 R20?
Neither in general. 245/45 R20 has the taller sidewall, which usually rides more comfortably; 245/40 R20 usually steers more sharply. The size listed for your car's trim, on its placard or in the handbook, is the safe default.
Check the exact tyre
Size codes give nominal dimensions. Before buying, confirm the size is approved for your car and check the exact tyre's load and speed ratings and published dimensions.