2007–2014 · three-door hatchback
The Corsa D VXR uses five-stud hubs, unlike many ordinary Corsa D models. Factory 17-inch and 18-inch packages are square; owner builds show wider 18-inch wheels and spaced original wheels on lowered suspension.
5x110 bolt pattern · 65.1 mm centre bore · Stock wheels: 17 × 7, 18 × 7.5 inch · Stock tyres: 215/45 R17, 225/35 R18
Updated 2026-10-04 · High source confidence. Check your exact trim and market. How we check specs
| Specification | Value |
|---|---|
| Bolt pattern | |
| Stock tyre sizes | |
| Centre bore | 65.1 mm |
| Fastener and thread | Wheel bolt, M12x1.5 |
| Tightening torque | 110 Nm (confirm in your handbook) |
Factory options vary by trim and market. Match your car to the row below and check its tyre placard before using it as a baseline.
| Trim | Axle | Wheel | Tyre |
|---|---|---|---|
| VXR, standard 17-inch | Front and rear | 17 × 7 inch, ET44 | 215/45 R17 |
| VXR, optional 18-inch | Front and rear | 18 × 7.5 inch, ET47 | 225/35 R18 |
Read these before choosing wheels for the Corsa VXR: they explain the offset, fitment and hub numbers in this guide.
Starting points for a build. Read the notes with each setup, especially if your car is lowered or has different brakes.
An OPC owner records this combination with 35 mm H&R springs, no spacers and no arch modifications. Another owner documents the same dimensions on Voltec T6 wheels. Check the actual wheel and tyre shape.
An OPC owner documents original wheels with 15 mm spacers per side and H&R 35 mm springs, without reported arch work. The wheel itself remains ET47; the spacer gives an effective ET32. Correct longer bolts are required.
Check the exact setup
There is no confirmed range for this car yet. Compare a known wheel with your proposed size and measure both sides.
Measure before ordering
A maximum width has not been confirmed. Tyre shape, ride height and alignment all change the available space.
These figures belong to the setups described here. Combining the widest wheel with either end of the offset range does not guarantee a safe fit. For how ET moves the wheel in and out, read wheel offset explained; for how far the tyre can sit out, see flush, poke and tucked fitment.
Upload a photo and start with a look that suits the Corsa VXR. Try the wheels, colour and stance before you spend on parts.
An AI preview shows the look. It cannot verify physical fitment.
These tools start with the VXR, standard 17-inch front size. Choose your own trim or axle in the calculator if it differs.
It is 5x110 with a 65.1 mm centre bore and M12x1.5 wheel bolts.
The standard 17-inch package uses 215/45 R17; the optional 18-inch package uses 225/35 R18.
Many ordinary Corsas use four-stud wheels, which do not fit the five-stud VXR hubs.
The Vauxhall handbook specifies 110 Nm.
Factory wheels are 17 × 7 inch and 18 × 7.5 inch, depending on trim. The stock table lists the offset for each.
65.1 mm. Aftermarket wheels with a larger bore need hub-centric rings sized to it.
This guide is a starting point, not a fitment guarantee. Specs can differ by market, trim and previous modifications. Confirm all sizes, clearances and fastener requirements with a qualified wheel and tyre professional before buying or fitting parts.
More guides from Vauxhall or cars with the same bolt pattern. A matching pattern alone does not make a wheel interchangeable.